Revolver Hubs - 1/4-28 Right Front Big Bell Tapered Bearing

Our Big Bell hub helps reduce the amount of flex between the wheel and the hub by increasing the contact patch. In some cases, racers may notice the imprint of a hub in the back of the wheel when racing with increased side loads. This solves that problem!

Our new and improved design with recessed pocket for the stud to fit flush into the backside of the hub.  That press in look, without the press in problems! This hub comes with tapered bearings bearings (angular contact). This bearing helps in cases where you may experience increased side loads. Some customer have reported that switching to tapered bearings has reduced vibrations in the front end. Made from 7075 aluminum. Comes with stepped (5/8 and 3/4) bearings. Cut rotating weight and look good doing it!

Titanium studs are NOT recommended for use on syrup tracks indoors.

Aluminum front dust cover, studs, and nuts sold separately!

This hub uses dust covers SKU# FTRHRFTD and FTRHLFSD.

Weights (No studs, bearings, spacers, or races):

LF - 76g

LF Stepped - 76g

RF Sealed - 116g

RF Tapered - 120g 

RF Big Bell Sealed - 159g

RF Big Bell Tapered - 162g