Titanium 600/TQ 9.5inch Rear Rotor

Our newest innovation of our 600 and TQ rear brake rotor. Cut from sheet and machined with precision, this grade 5 titanium rear brake rotor offers performance and longevity. 

This rotor fits a standard brake/gear carrier and can be used on 1.75 or 2 inch rear axles. The outer diameter is 9.5 inches and the thickness is .215 inches, putting it just below 1/4 and just thicker than 3/16.  Long, laid down slots help cut weight while allowing gas to vent and air to aid in cooling. The rotor comes in at just 1.2lbs.

We recommend either Wilwood BP28 or BP40 brake pads to be used with this rotor. BP28 pads will offer less cold friction but better pad wear. BP40s will wear faster but offer hard hitting, aggressive bite onto the rotor. Bed the rotor and pads starting with a series of light deceleration to build heat allowing 3-5 seconds between cycles. After that, begin to warm the pads and rotor with medium to firm braking. Once the temperature rises, finish by bedding with hard stopping from 55-65 MPH, slowing to 25 MPH 8-10 times until the pads provide positive and consistent response.

Never clean titanium with chlorinated brake clean or other cleaners. If you do not know, its best to avoid it all together. Never allow brake fluid to contact the rotor or pads when bleeding.